美国材料协会标准 A265 - 12 (2019).pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A265 − 12 (Reapproved 2019) Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate1 This standard is issued under the fixed designation A265; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope A751 Test Methods, Practices, and Terminology for Chemi- 1.1 This specification2 covers plate of a carbon steel or cal Analysis of Steel Products low-alloy steel base to which is integrally and continuously B127 Specification for Nickel-Copper Alloy (UNS N04400) bonded on one or both sides a layer of nickel or nickel-base Plate, Sheet, and Strip alloy. The material is generally intended for pressure vessel use B162 Specification for Nickel Plate, Sheet, and Strip but may be used in other structural applications where corro- B168 Specification for Nickel-Chromium-Aluminum Alloys sion resistance of the alloy is of prime importance. (UNS N06699), Nickel-Chromium-Iron Alloys (UNS