齿轮检测注解.pdf

1 Number of work piece teeth z is at z ·Positive external gear e.g.:12 12 ·Negative internal gear e.g.:-12 -12 2 Length Ev. La L Evaluation length L for profile L 3 Length EvLb Evaluation length L for flank L 4. Appr. Length M1 M1 Start of evaluation for profile(M1) M1 5.Designation: Compensation with compensation number 6 Definition of side left/right / 7 Profile designation Tip/Root / 8 Flank designation Top /Bottom / 9 Evaluation standard, e.g.: DIN 3962DIN3962 10 Designation of type of evaluation, e.g.: PROFILE 11 Designation of flank, e.g.: PULLING/PUSHING / 12 Material indication: plus(+)/minus(-) +/ - 13 Number of measured tooth 14 Variance - is the difference between the smallest and largest angle error without torsion (toothnumber1a + 1c) - 1a+ 1c 15 Number of measured tooth and designation of torsion(1a=bottom 1b=center,1c=top Largest existing measured value is outputted with quality level (with DIN evaluation) 1a=1b= 1c = DIN 16 Tolerance values and related quality level (depends on selected type of evaluation) 17 Indication for sign control according to set type of evaluation 18 Designation of type of measurement: LEAD Or GENERANT 19 sign control VDI or DIN 20 Material indication :plus(+)/minus(-) +/ - 21 Calculation of angle error to N:Z,N A, N:10 NZNAN10 22 Variance-is the difference between the smallest and largest angle error without torsion (tooth number 1a+1c) 1a+1c 23 Number of the measured tooth and designation of torsion (1a=inside, 1b=center, 1c=outsid