IBM小型机启动LED代码解释.doc

RS/6000液晶显示屏上显示代码(LED)的含义 本文介绍RS/6000启动过程中机器上的液晶显示屏代码的含义。本文代码不针对具体机型。 ? ---------- Dump Progress Indicator ---------- ? ? 0c0 The dump completed successfully 0c1 The dump failed due to an I/O error. 0c2 A user-requested dump has started. You requested a dump using the SYSDUMPSTART command, a dump key sequence, or the Reset button. ? 0c3 The dump is inhibit 0c4 The dump did not complete. A partial dump was written to the dump device. There is not enough space on the dump deviceto contain the entire dump. To prevent this problem from occuring again, you must increase the size of your dumpmedia. ? ? 0c5 The dump failed to start. An unecpected error occured while the system was attempting to write to the dump media. 0c6 A dump to the secondary dump device was requested. Make the secondary dump device ready, then press CTRL-ALT-NUMPAD2. 0c7 Reserved. 0c8 The dump function is disabled. No primary dump device is configured. 0c9 A dump is in progress. 0cc Unknown dump failure ? ? ? ? ? ---------- Diagnostics Load Progress Indicators ----------- ? ? c00 AIX Install/Maintenance loaded successfully. c01 Insert the first diagnostic diskette. c02 Diskettes inserted out of sequence. c03 The wrong diskette is in the drive. c04 The loading stopped with an irrecoverable error. c05 A diskette error occurred. c08 RAM filesystem started incorrectly. c07 Insert the next diagnostic diskette. c09 The diskette drive is reading or writing a diskette. c20 An unexpected halt occured, and the system is configured to enter the kernel debug program instead of entering asystem dump. ? c21 The ifconfig command was unable to configure the network for the client network host. c22 The tftp command was unable to read clients ClientHostN file during a client network boot. c24 Unable to read clients ClientHostN file during a client network boot. c25 Client did not mount remote miniroot during network install. c26 Client did not mount the /usr filesystem during the network boot. c29 System was unable to