御塑_POM 卤素报告 (2).pdfVIP

化學實驗室-高雄 試驗報告 號碼 :KE/2018/20345A-01 日期 :2018/02/12 頁數 :1of4 台灣塑膠工業股份有限公司 台北市敦化北路201號8樓 以下測試樣品係由客戶送樣, 且由客戶聲稱並經客戶確認如下 ： 樣品名稱 : 台塑鋼 樣品型號 : FM090 樣品材質 : 聚甲醛 樣品顏色 : 本色 收件日期 : 2018/02/06. 測試期間 : 2018/02/06TO2018/02/12 送樣廠商 : 台灣塑膠工業股份有限公司 測試結果 : 請見下一頁. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested. This test report cannot be reproduced, except in full, without prior written permission of the Company. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at /terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at /terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law.