2ECE R1装有R2和HS1白织灯机动车前照灯.pdf

E/ECE/324 )Add.1/Rev.4/Amend.2 E/ECE/TRANS/505) page 2 Title, amend the words ... OF CATEGORY R2 to read ... OF CATEGORIES R2 AND/OR HS1. Insert a new paragraph 1.3.7., to read: 1.3.7. The holder intended to accommodate the filament lamp (or lamps) of one of the following categories: R2 and/or HS1; 2/ Note 2/, add to the existing text: ’Type of filament lamp’ should not be confused with ’category of filament lamp’. This Regulation concerns headlamps using filament lamps of categories R2 and/or HS1. These categories of filament lamps differ essentially in their design and, more particularly, in the cap. They are not interchangeable, but within one filament lamp category there are normally several types. Paragraph 4.2.1.1., footnote 5/, amend to read: 5/ 1 for ..., 8 for the Czech Republic, ... 23 for Greece, 24 (vacant), 25 for Croatia, 26 for Slovenia and 27 for Slovakia. Subsequent numbers ... Paragraph 5.4., add to the existing text: The filament lamp-holder shall conform to the dimensional characteristics as given in the following data sheets of IEC Publication 61-2: Filament lamp Holder Data sheet R2 P45t-41 7005-95-1 HS1 PX43t 7005-34-1 Paragraph 6.1., amend to read: 6.1.1. Headlamps shall be so made that with suitable R2 and/or HS1 filament lamp(s) they provide adequate illumination without dazzle in the case of passing beam and good illumination in the case of the driving beam. 6.1.2. The illumination produced by the headlamp shall be checked on a vertical screen set at a distance of 25 m in front of the headlamp and at right angles to its axis (see annex 6). GE.95-24009 (E)