GMW 15382-2007 密封条接缝处的试验.pdf

WORLDWIDE Test Procedure ENGINEERING GMW15382 Materials STANDARDS Tests at Joints in Weatherstrips may be run on the complete part or on a portion of 1 Scope the part i.e., the bulb section only of a dual durometer weatherstrip. This standard covers the test methods for all joints in weatherstrip applications, including but not 5.1.2 Method B: Temperature Stability for limited to molded, mitered, wafer-spliced, and Joints. This test method is designed to determine adhesively bonded joints. the temperature stability of a joint in a weatherstrip. Note: Nothing in this standard supersedes 5.1.3 Method C: Bending Strength of Joints. applicable laws and regulations. This test method is designed to determine the bending strength of a joint in a weatherstrip. Note: In the event of conflict between the English and domestic language, the English language shall 5.2 Test Sample Preparation. take precedence. 5.2.1 Method A: Cut weatherstrip section approximately 150 mm in length, with splice 2 References