c308-95中文版-抗化学腐蚀树脂灰浆加工时间、凝固时间及使用强度下凝固时间的标准试验方法.docVIP

C 308 Designation：C 308 – 95编号：C 308 – 95 Standard Test Methods for Working, Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars These test methods are under the jurisdiction of Committee C-3 on Chemical-Resistant Nonmetallic Materials and are the direct responsibility of Subcommittee C03.01 on Test Methods.本试验方法由C-3耐化学腐蚀的非金属材料委员会管辖，并由C03.01试验方法分委会直接负责。Current edition approved Nov. 10, 1995. Published January 1996. Originally published as C 308 - 53 T. Last previous edition C 308 - 85 (1990). These test methods are under the jurisdiction of Committee C-3 on Chemical-Resistant Nonmetallic Materials and are the direct responsibility of Subcommittee C03.01 on Test Methods.本试验方法由C-3耐化学腐蚀的非金属材料委员会管辖，并由C03.01试验方法分委会直接负责。Current edition approved Nov. 10, 1995. Published January 1996. Originally published as C 308 - 53 T. Last previous edition C 308 - 85 (1990).现行版本于1995年11月10日批准，并于1996年1月出版。最初版本编号为C308-53T，上一版本编号为C308 This standard is issued under the fixed designation C 308; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 308刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示必威体育精装版重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 These test methods cover the determination of the working, setting and service strength setting times of chemical-resistant resin mortars.本试验方法包含抗化学腐蚀树脂灰浆加工、凝固及使用强度下凝固时间的测定。 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.以标准国际单位表述的数值为标准值。括号内的数值仅供参考。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the