AASHTO M 213-2001(2010) 国外国际标准.pdf

Standard Specification for Preformed Expansion Joint Fillers for Concrete Paving and Structural Construction (Nonextruding and Resilient Bituminous Types) AASHTO Designation: M 213-01 (2010) ASTM Designation: D 1751-04 (2008) 1. SCOPE 1.1. This specification covers preformed expansion joint fillers having relatively little extrusion and substantial recovery after release from compression. 1.2. The values stated in SI units are to be regarded as the standard. Note 1—Attention is called to M 153 and to M 33. 2. REFERENCED DOCUMENTS 2.1. AASHTO Standards : M 33, Preformed Expansion Joint Filler for Concrete (Bituminous Type) M 153, Preformed Sponge Rubber and Cork Expansion Joint Fillers for Concrete Paving and Structural Construction T 42, Preformed Expansion Joint Filler for Concrete Construction 3. ORDERING INFORMATION 3.1. Products conforming to this specification are manufactured in sheet form to a range of thicknesses; namely, 6.4, 9.5, 13, 19, and 25 mm. Sheet sizes may be 900 or 1200 mm in width and standard length of 3 m. Purchaser must specify sheet sizes when ordering. 3.2. Joint filler in strip form is cut from the sheets as manufactured. When ordering joint filler strips, the purchaser must specify thickness, width, and length; strip widths are available from 50 mm in increments of 13 mm. 4. MANUFACTURE 4.1. This product shall consist of preformed sheets or strips made of one of the following: 4.1.1. Cane or other suitable fibers of a cellular cellulosic nature securely bound together and then uniformly saturated with asphalt; TS-4e