10全氧燃烧系统启动操作手册-AXXDX-SCSB-CZWH-010.docxVIP

Start-Up Sequence Oxy/Fuel Burner System Doc. No. :PRO-2014-CN-022 Rev. No. : 1.0 Date : July 15, 2014 Rev Date Authors Signature 1.1 DATE \@ MMMM d, yyyy January 7, 2015 P. van Kampen PAGE 3 Typical Start-Up Sequence Oxy/Fuel System 全氧燃烧系统启动顺序 PRO-2014-CN-022 Release Version Date Creator Pages modified- Comments Verified Approve 0.0 2014/07/1 PvK Original LO Copyright: This manual is copyrighted by AIR LIQUIDE with all rights reserved. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of AIR LIQUIDE. No patent liability is assumed, however, with respect to the use of the information contained herein. Disclaimer: This manual has been validated and reviewed for accuracy. The sets of instructions and descriptions were accurate at the time of this manuals production. However, succeeding manuals are subject to change without modification. Read carefully the warning message.  Contents TOC \o 1-3 \h \z \u 1 Introduction 介绍 4 2 Operating Procedures 操作步骤 4 3 Purging Requirements 清洁需求 6 4 Start-Up Sequence 启动顺序 7 5 Hold Fire Mode 保持火焰模式 9 6 Ratio Calculations Set points 比例计算设定点 9 7 Shut Down of Burner 燃烧器完全关闭 9  Introduction 介绍 This document describes a typical start-up procedure for an oxy/fuel burner system mounted on a tilting rotary furnace (TRF). AL assumes that the furnace has a front door which the stack and burner attached. This door can move 90? from the furnace for loading of the furnace. A minimum amount of interlocks should be present to guarantee safe start-up and operations. 该文件介绍了使用在转炉（TRF）上全氧燃烧系统的典型启动步骤。法液空假设炉门在前端，炉门上带有烟囱与燃烧器。装料时，炉门可以相对炉体移动90?。少量的联动装置需要在启动与操作前被执行用以保障安全。 Operating Procedures 操作步骤 Prior to starting the combustion system for the first time makes sure all valves are closed on the valve train and that all the connections to the burner have been made. Notify appropriate personnel that start-up is imminent. 首次启动燃烧系统之前，确保阀组上所有阀门处于关闭状态。所有和燃烧器相关的连接均已完成。告知