CISCO路由器配置(2)陆小马功钟浩.ppt

Show Protocols Router# show protocols Global values: Internet Protocol routing is enabled DECNET routing is enabled XNS routing is enabled CLNS routing is enabled (address 47.80ff.f800.0000.ffff.0021.1830.8002.00) Vines routing is enabled Appletalk routing is enabled Novell routing is enabled --More-- Ethernet0 is up, line protocol is up Internet address is , subnet mask is 28 Decnet cost is 5 XNS address is 3010.aa00.0400.0284 CLNS enabled Vines metric is 32 AppleTalk address is 3012.93, zone ld-e0 Novell address is 3010.aa00.0400.0284 --More-- Ping测试 Router ping Type escape sequence to abort. !!!!! Success rate is 100 percent, round-trip min/avg/max = 1/3/4 ms Router Sending 5, 100 byte ICMP Echos to , timeout is 2 seconds: Echo Request Echo Reply Network Layer 接口配置 ? For a serial interface to provide clocking (DCE), use a clockrate command Router(config)# interface serial 1/0 Router(config-if)# bandwidth 56 Router(config-if)# clockrate 56000 密码配置 Virtual Terminal Password Enable Password Router(config)# line console 0 Router(config-line)# login Router(config-line)# password cisco Console Password Router(config)# line vty 0 4 Router(config-line)# login Router(config-line)# password cisco Router(config)# enable password san-fran Perform Password Encryption Router(config)# service password-encryption (set passwords here) Router(config)# no service password-encryption IP地址配置 ip address ip-address subnet-mask Router (config-if) # CLI配置命令与EXEC模式 　 CLI配置命令与EXEC模式 Following commands are used to switch between user and privileged modes, as depict in the diagram. Enable : turn on privileged commands. Disable : return to user mode. * The most useful commands are show startup-config or show running-config. ? Show startup-config displays the image size and the startup configuration commands. This command shows the amount of memory being used. Show running