fanuc ladder 操作B-66234EN_08使用说明.pdf

FANUC LADDER-Ⅲ OPERATORS MANUAL B-66234EN/08 • No part of this manual may be reproduced in any form. • All specifications and designs are subject to change without notice. The products in this manual are controlled based on Japan’s “Foreign Exchange and Foreign Trade Law”. The export from Japan may be subject to an export license by the government of Japan. Further, re-export to another country may be subject to the license of the government of the country from where the product is re-exported. Furthermore, the product may also be controlled by re-export regulations of the United States government. Should you wish to export or re-export these products, please contact FANUC for advice. In this manual we have tried as much as possible to describe all the various matters. However, we cannot describe all the matters which must not be done, or which cannot be done, because there are so many possibilities. Therefore, matters which are not especially described as possible in this manual should be regarded as ”impossible”. This manual contains the program names or device names of other companies, some of which are registered trademarks of respective owners. However, these names are not followed by ® or ™ in the main body. B-66234EN/08 PREFACE PREFACE Thank you for purchasing FANUC LADDER-III. FANUC LADDER-III is a programming system for developing sequence programs for FANUC PMCs. ® ® This software runs under the Microsoft Windows environment. This manual does not cover common basic Windows operations. If you are a beginner to Windows, read the Windows manual first to learn the basic Windows operations. This manual describes the programming system-spe