普通胶合板测试报告..docxVIP

检测报Test Report 检测工程: 普通胶合板 Test ItemsPlywood for General Use 委托单位: 狮山冠锋木业制品 Applicant Shishca Guanfeng Wood Products Co, Ltd. 检测类别：委托检验Test TypeEntrusted Test 收样日期：2018-10-22Received Date October 22nd,2018 考前须知 Precautions .检测报告无本单位检测专用章或骑缝章无效。 Test report is invalid if not affixed with Authorized Stamp of Test or Paging Seal. .检测报告无审核人、批准人签字无效。 Test report is invalid without signature of verifier and approver. .检测报告涂改增删无效。 Test report is invalid only if being supplemented, deleted or altered. .未经本单位书面许可不得局部复制检测报告(全部复制除外)。 Without prior written permission of HJK, the test report cannot be reproduced, except in full. .除非另有说明，本报告检测结果仅对测试样品负责。 Unless otherwise stated, the results shown in this test report are responsible for the delivered sample(s). .对检测报告假设有异议，应于收到报告之日起十五天内向检测单位提出。 Objections to the test report must be submitted to HJK within 15 days of report received date. .样品信息由送样人提供，实验室不负责核实信息真实性。 The test applicant is responsible for authenticity of sample information which not subject to verification of HJK LAB. .上海宏骏科技实验室具备由美国IAS认可的满足ISO/IEC 17025要求的资质。 Shanghai Hongjun Science Technology Co., Ltd. is an ISO/IEC 17025-conforming test laboratory, which is accredited by International Accreditation Service, Inc. .样品描述/Sample Description 收到的样品为普通胶合板，样品包装完整、状态完好。样品规格尺寸如下表所示。 The samples received are Plywood for general use. All test samples are packed well and kept in good conditions. The dimension specifications of the samples are shown in below table. 测试工程 尺寸规格 长*宽*厚(mm) 数量(片) 含水率 Moisture Content 100*25*8.5 3 胶合强度 Bonding strength 100*25*8.5 12 浸渍剥禺 Impregnation Delamination 75*75*8.5 6 抗弯强度 Bending Strength 220*50*8.5 12 弹性模量 Bending Modulus of Elasticity 220*50*8.5 12 甲醛释放量 Formaldehyde Emission 250*150*8.5 3 .检测标准/Testing Standards 根据客户要求，样品根据如下标准进行测试： According to applicanfs requirements, the samples are tested according to the following standard: GB/T 9846-2015普通胶合板GB/T 17657-2013人造板及饰面人造板理化性能试验 ASTM D6007-2014 Standard Test Method for Determining Formaldeh