EMERSON艾默生 Instruction Sheet Explosionproof Rigmaster LED Series Luminaires with Emergency Battery Backup, 650611-000 Appleton说明书用户手册.pdf

Safety Instructions for Luminaire (Continued) NOTICE: • Do not touch the LEDs; touching could leave oily deposits, causing hot spots and potential premature failure. • The LED glass lens should be cleaned periodically from the outside only with a moist cloth to maintain lighting efficiency. • The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. • This luminaire is designed for and should be installed with hazardous locations wiring method required in accordance with the National Electrical Code® ® (NEC )/Canadian Electrical Code and all applicable local codes. • This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and hazards involved. • Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel. • Do not use this equipment for other than its intended use. SAVE THESE INSTRUCTIONS Applications/Intended Use • Areas where flammable gases and vapors are present under conditions defined by the ratings below. • Areas of low clearance, low ceiling heights, or where luminaire weights must be minimized. • Ideal for use in chemical and petrochemical plants, such as manufacturers of plastic, paints and thinners; in refineries and other process areas where ignitable vapors, dust, moisture, and corrosive elements may be present. • Where flexible cord is used, it should be approved for extra hard, wet location usage and shall have a separate ground conductor. • Make sure to tighten unused close-up plugs after applying corrosion-inhibiting grease for example TLNC4 grease or equivalent. TLNC4 grease shall be applied in 3 lines, spaced approximately 120 degrees apart, perpendicular to the threads. • Luminaire is suitab