Dell戴尔Dell Technologies PowerFlex Custom Node Hardware Configuration and Operating System Installation Guide for Linux说明书用户手册.pdf

Dell Technologies PowerFlex Custom Node Hardware Configuration and Operating System Installation Guide for Linux May 2022 Rev. 03 Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2020 – 2022 Dell Inc. or its subsidiaries. All rights reserved. Dell Technologies, Dell, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other trademarks may be trademarks of their respective owners. Contents Chapter 1: PowerFlex custom node deployment overview 5 Supported operating systems and requirements5 PowerFlex packages 5 Hardware and operating systems5 PowerFlex component requirements6 PowerFlex cluster components6 PowerFlex Gateway server requirements6 General prerequisites 7 Supported Internet browsers7 Connectivity requirements7 Disk prerequisites7 iDRAC Service Module7 Additional requirements for NVDIMM7 Supported hardware configurations 8 Additional equipment and network resource requirements8 Chapter 2: Configuring the hardware 9 Set up the iDRAC IP address and BIOS 9 Log in to the iDRAC virtual console10 Verify the status of the system hardware and drives11 Updating the BIOS, firmware, and settings12 Update the hardware using the iDRAC virtual console12 Chapter 3: Installing the Linux operating system 14 Linux system requirements14 Rebuild the M.2 cards as a RAID 1 device14 Map the Linux ISO file on a PowerFlex custom node 15 Optim