基恩士 CV-X 系列 便捷设定手册 控制与通讯篇 IO EN.pdf

657GB Control/Communication I/O (for all PLC models) (CV-X400) This manual has been written for the CV-X400 Series. For details on the CV-X100 Series or CV-X200 Series, see their respective manuals. Documentation for the installation and coniguration methods of the controller, and CAD data can be downloaded from the following URL. www.keyence.co.jp/gazo /cvx_support Copyright© KEYENCE CORPORATION. All rights reserved. Contents Easy Setup Guide: Control/Communication I/O (for all PLC models) (CV-X400) 1. Outputting the Total Status Page 3 2. Outputting the individual status of each tool (parallel I/O) Page 11 3. Terminal command control Page 17 KEYENCE CORPORATION. Vision System Division Outputting the Total Status 1. Wiring Perform the following wiring to output the total status of inspections. This section explains how to wire the terminal block OUT22:STO UT23:OR to a PLC or relay. (The terminal block is attached to the main unit) This manual has been written for the CV-X400. When wiring the CV-X100 Series or CV-X200 Series, see their respective manuals. Controller terminal block (OUT connector) No. Terminal name　*1 1 OUT22 （STO） 2 OUT23 （OR）