基恩士 IV 系列 开始指南 PC软件篇V.pdf

96M14941 Ultra Compact Vision Sensor IV-G/IV-HG Series Vision Sensor IV/IV-H Series Starting Guide (PC Software) The Starting Guide describes the basic operations from setting up until starting the operation for IV Series. For details of functions, refer to the User’s Manual (PC Software). yThe User’s Manual (PDF) can be viewed inside the folder where the IV-Navigator was installed or from the “Help” menu of the IV-Navigator. Operation flow Mounting, connecting, and wiring the sensor, and installing the PC Software for IV Series Mount the sensor, and connect and wire the cable. And then, install the PC software for IV series to the PC. Turning on the power Turn on the power of the sensor, and then perform the initial start-up setting. “Operation when the power is turned on” (Page 4) Settings Navigator Create the program to be used for operation in [Settings Navigator] (Sensor Setup). STEP 1: Setting of image optimization Set the image optimization for clearly imaging a target. Adjust the image for defining the differences in the high and low-quality-target. Set the trigger option, adjust the brightness and imaging focus. “STEP1 Setting the Image Optimization” (Page 5) STEP 2: Registration of master image Image the high-quality-target and register the master image to serve as the reference of judgment. “STEP2 Registering the master image” (Page 7) STEP 3: Tool settings Set the tool to judge a target. Set the tool onto the master image and set the threshold for judgment. Up to 16 detection tools and 1 position adjustment tool in one program can be set. “STEP3 Setting the detection tool” (Page 7) STEP 4: Output assignment Assign the function to output to each output lin