供应商表现发展过程PPAP(1).pptxVIP

Supplier Performance Development Process20-Sep-99Task 15: PPAP1Task 15 PPAP Task DescriptionProduction Part Approval Process (PPAP) Production parts are manufactured at the production site using production toolPiPnAgP, gaging, equipment, operators, etcParts from production run are analyzed Test results and records from APQP are submitted with Part Submission Warrant20-Sep-99Task 15: PPAP2 PurposeFor the supplier to demonstrate– all design records and specification requirement are properly understood– the process has the capability to produce product that meets requirements20-Sep-99Task 15: PPAP3 Something ChangedApplicationAIAG PPAP manual defines when PPAP submission is required– New part– Correction to discrepancy in previou submission– Design or process change– Change in source of subcontracted materials or services– transfer or rearrangement of toolingeqTauski1p5:mPePnAPt20-Sep-994 Methodology Buyer enters PPAP submission date on purchase order Approver determines submission level– default level 3Supplier submits PPAP– PPAPALL.xls electronic submission recommended20-Sep-99 Task 15: PPAP Approver evaluates PPAP package– Level 5 at supplier sit Approver determine part submission status– default level 4 for raw mate?riaNlotify supplier andmanufacturing of status5 DFMEAControl Plan Early Production Containment Plan (Pre-Launch Control Plan)Process capability studies Gage Measurement System AnalysisLab Accreditation scope Restricted Reportable Materials formSupplier Data Received?Warrant Appearance Approval Report (AAR), as requiredSample PartsPrint/Design Record Engineering Change DocumentsCheck fixtures/aids Process Flow Diagram2P0-FSeMp-E99A?Task I15n: tPPeAPrim Worksheet, if require6 d PPAP Review Checklist Delphi checklist to assist with evaluation ofPPAP package Action plan created with use of checklist20-Sep-99Task 15: PPAP7 Flow Chart Linkage of Product Characteristics from DFMEA to Operational Steps Operation numbers consistent with PFMEA, Control Pl