哈斯操控面板加工中心.pptVIP

* This gives you metric to decimal conversion as well as drill and tap size equivalents. * Shown are some important Settings to remember. * This shows the Graphics mode with PROG(RAM) and POSITION selected. F2 and HOME returns zoom to full table view. Graphics can be run in single block and DNC also. POSITION can be set at any of the 4 options with the arrow keys Rapid path and drill points can be turned on or off in Settings. If you encounter an alarm while running a program, you can press EDIT and the cursor will be on the line where the problem occurred. * You can use the Parameter Program to convert the large decimal number to the binary bits representing each parameter. * If two opposite switches are both 1 or both zero, there is obviously a problem. What if all the inputs were zero (or one)? Problem with I/O board or Ribbon cable. * In Debug on newer machines, you can also see the last 200 keystrokes (in Current Commands). In M16.xx and L09.xx you see 1000 keystrokes. * These buttons will effect machine operation. * There are eight different keys under the “Display” area. Some of these have several functions or screens. * These buttons allow you to perform certain limited functions, such as turn on the coolant and Chip conveyor, orient the spindle (to tool change position) and perform a tool change. * You can also write and execute programs in MDI. Normally these would be simple programs that you don’t care about saving to memory. * These buttons are for jogging the axes and for setting your Dry Run feed rates. MDI/DNC 键: PROGRAM (MDI) O91002 N00000 ; 如果要保存 在 MDI 里的程序 输入程序名 按 ALTER G01 Z-0.0337 F7. ; G01 X-0.5687 Y-0.9857 ; G01 X-0.2275 ; G01 X0.1314 Y0.2275 ; G01 X-0.2275 ; G01 X0.1314 Y0.2275 ; G01 X-0.7835 ; G01 X0.1314 Y0.2275 ; G01 X0.7835 ; G01 X-0.5687 Y-0.9857 ; G01 X-0.2275 ; G01 X0.1314 Y0.2275 ; G01 X-0.7835 ; G01 X0.1314 Y0.2275 ;