轴流叶片导入AxCent流程x.pptx

Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.1轴流叶片导入AxCent流程钱煜平、黄洪磊yuping.qian@xecaturbo.cn；support@xecaturbo.cn

1、将进出口边修整为shearedThematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.2

2、CADTranslator打开叶片文件Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.3

3、设置导入格式和叶片数等压力面吸力面叶片数和离散点数Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.4

4、截取压力面流线1.选择面2.鼠标单击选择5.设置压力面流线数目和位置3.选中压力面4.截取流线Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.5

5、截取吸力面流线1.选择面2.鼠标单击选择5.设置吸力面流线数目和位置3.选中吸力面4.截取流线Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.6

6.确认流向和旋转轴Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.7

7、设置线条选择和流线方向显示等收集流线单击压力面和吸力面选择线显示流线方向鼠标单击选择Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.8

8、选择压力面前盖板流线3.确认流线方向2.单击选中压力面轮毂流线1.单击压力面4.完成流线收集Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.9

9、完成其他流线收集完成其他流线收集，注意顺序为压力面轮毂到轮缘，吸力面轮毂到轮缘Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.10

10、另存为.SUR文件Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.11

11、AxCent打开.SUR文件Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.12

12、选择“Surfacesection”模式Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.13

13、调整轮毂轮缘拟合曲线Thematerialcontainedhereinisproprietaryandconfidential.?2013ConceptsETI,Inc.Allrightsreserved.1